In addition, there is a very active contributor, who seems to be very decisive (good and bad) and in control about which improvements are approved and which are not. IT is much more a finished program for the normal user that just wants to run trains. JMRI is great for decoder programming and setting up signal logic, but some of the other stuff they keep cramming in I have to question. The first experiments with RocRail seemed to indicate that RocRail was easier to use than JMRI. Code should be indented for readability, not because it uses that to denote procedures and other types of code blocks. Who ever though that was an great idea? I have no idea why anyone would use it. And he's a lawyer - I'm the computer guy.ĪNd I'm sorry, any programming or scripting language that relies on proper indenting is a complete non-starter (jython). Peter Gilling, designer of the board, advised on reducing the value of the resistor R1 I am currently using 390 ohms-, this is also convinent for usb-rs232 converters. The booster board ( ord-3) is powering the test track. Peter Gilling, designer of the board, advised on reducing the value of the resistor R1 I am currently using 390 ohms-, this is also convinent for usb-rs232 converters. Rocrail is using the ddx library to send the commands through the serial port of the rpi. and applications like JMRI, Engine Driver, WiThrottle, Rocrail and more. MattzoControllers natively understand the WIO Rocrail protocol. In the MattzoBricks Train Automation System 2.0, it is used as the automation computer, and therefore as the backbone of the overall platform. CVs and testing, but SPROG3 can even be used for running larger layouts. ![]() The booster board ( ord-3 ) is powering the test track. you should check out the Xbox Elite Wireless Controller Series 2 at the. Rocrail is a free software for controlling model trains. and all well-known train controller software (RocRail, JMRI, iTrain etc). Between visits, he downloaded a trial of RR&Co Silver and had the whole thing working the next time I came over, 4 sets of trolley cars following each other at least one block apart and it ran for hours with no faults. Rocrail is using the ddx library to send the commands through the serial port of the rpi. Start setting up the automatic script and section 5 would go occupied along wih section 11 which is where the trolley really was. a signal using just one occupancy sensor (like RocRail and iTrain does). ![]() I could run a trolley manually and monitor the detections and they were all fine. Besides a couple of false starts since it seems nearly impossible to undo a mistake in setting up the track (removed the bad piece, put in a new one, but in the end it acted like the removed part was still there - dang XML for a database.), I was also getting spurious detections constantly. A friend of mine wanted to set up multiple trolleys to run through his oen town, so I tried doing it with JMRI. Program to test communicating directly with NCE USB over COM port. For automation, I'd give the nod to RR&Co. Sometimes I also want to go beyond what JMRI or RocRail offer and have direct control.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |